Doubletake Mirrors
Doubletake Mirrors
Which parts for which bike?
Beta
- RAM-B-349U will thread into existing mirror mounts.
- DTM-KTM will add a mirror mount to any master cylinder split horizontally.
BMW
- F800/ R1200: BMW Base RAM-B-349U-1
- Some F650 singles: Toughball Base RAP-B-379U-M81208
- Some F650 singles: RAM-B-349U
- Older: Plate base RAM-B-252U flat with 11mm hole, customer to supply bolt
Honda
- RAM-B-349U will thread into existing mirror mounts.
Husqvarna
- RAM-B-349U will thread into existing mirror mounts.
- DTM-KTM will add a mirror mount to any master cylinder split horizontally.
Kawasaki
- RAM-B-349U will thread into existing mirror mounts
- On KLRs, you will need a DTM- Extension to clear the OEM hand guard.
KTM
- RAM-B-349U will thread into existing mirror mounts.
- DTM-KTM will add a mirror mount to any master cylinder split horizontally.
Suzuki
- RAM-B-349U will thread into existing mirror mounts.
Triumph
- RAM-B-349U will thread into existing mirror mounts.
Yamaha
- RAM-B-349U will thread into existing mirror mounts.
- Right side will require Yamaha adapter DTM-Yamaha which has 10mm x 1.25 normal female, and 10mm x 1.25 reverse male threads.
Dirtbikes
- The split clamp DTM-Split will allow mounting on any 7/8ths bar
- The horizontal clamp DTM-KTM will allow replacing the top half of most brembo master cylinders (clutch or brake on recent KTMs)
- RAM-B-347U will thread into either of these clamps to mount mirror.
Arm Lengths:
- For the Doubletake Enduro:
- RAM-B-201U - 3” overall length - most popular option.
- RAM-B-201UA - 2” overall length.
- For the Doubletake Adventure:
- RAM-B-201UC – 6” overall length.
- We do not offer a shorter arm with this product.
Installation: Enduro / Adventure
- Thread the RAM ball in and use the ARM to tighten. Do NOT use pliers, etc. which will gall the aluminum shaft of the base.
- If stud is unthreading, add silicone or lock tight of your choice to threads before threading in.
Installation: Trail Mirror
- Slide zip tie through Trail Mirror from the bottom side (the head of the zip tie should end up resting underneath the Trail Mirror housing).
- Slide rubber sleeve on to zip tie up to the mirror housing (this prevents the zip tie from moving on the bar).
- Install Trail Mirror in the most outboard location possible, this may require relocating other controls slightly. We suggest mounting the mirror on the right-hand side of the bike.
- Tighten zip tie as tight as possible to bar, and clip off excess zip tie.